6 Big Tips for Small Fixes Residents Can Do in the Homeowners Association

It’s the duty of an HOA Board to maintain common areas and some aspects of the individual homes in the Association; however it’s up to residents to take care of small maintenance jobs in their homes. Do-it-yourself projects can be immensely rewarding, but even a small repair can turn into a more frustrating and time-consuming job when you encounter unexpected problems. As an HOA Board member in your homeowners association consider providing these easy tips to residents to tackle common household hardware problems that will leave them with a sense of accomplishment rather than a sense of frustration. 

1.  Loose Screws

If a screw is so loose that it’s barely gripping, remove it, wrap its threads with a few strands of steel wool, and screw it back into its old hole. If a screw has been ripped out of its hole entirely and the hole is too big for the threads to gain hold, slide a wooden match into the hole and then replace the screw. 

2.  Tight Screws

Twisting screws into a bar of soap first makes them easier to insert. A few drops of white vinegar will help remove stubborn screws from a metal surface. 

3.  Better Grips

Improve your grip by wrapping a thick rubber band around the plastic handle of a screwdriver. This makes tightening and loosening screws less strenuous. 

4.  Hammer Help

When hammering a small nail, brad or tack, slip the fastener between the teeth of a pocket comb to protect your fingers from the hammer’s blow. Don’t have a comb handy? You can also use a bobby pin, a paper clip or tweezers to hold the nail. When hammering a nail in a tight spot or hard-to-reach corner, a bit of modeling clay or chewing gum will hold the nail in place for the first couple of blows. 

5.  Rusted Nuts and Bolts

Removing a rusted nut or bolt can be an especially frustrating task. Pour hydrogen peroxide, lemon juice or cola over the rusted fastener and wait half an hour. The mild acid will dissolve the rust enough for the nut or bolt to turn freely. 

6.  Rusted Tools

Working with rusted tools makes any job more difficult. Clean off the rust by rubbing a paste of six parts salt and two parts lemon juice on the rusted areas with a dry cloth, then rinse and dry thoroughly.

Again, providing these small tips for household Do-It-Yourself projects to residents in your homeowners association will help maximize their success and minimize their aggravation. Even the smallest bit of help from the HOA Board on a project can calculate into large rewards for the entire community.

What other DIY tips would you suggest to residents?

Related Articles:

3 Key Tasks a Homeowners Association Board Does for Residents

Tips to Discourage Burglars in Your Homeowners Association